18″ x 7,0 | 5×114,3

19″ x 7,5 | 5×114,3



CARBONADO rims are produced in modern factories using innovative technologies of manufacturing and processing of low-pressure castings from light alloys. Only selected raw materials of the highest test are being used. At every stage of production, each rim is subjected to a rigorous quality control. Selected models of CARBONADO rims are made using the flow forming method (rolling) providing even greater durability of rims and, at the same time, smaller mass.


The highest quality of CARBONADO rims is confirmed by the compliance certificates issued by the Automotive Industry Institute – PIMOT. This certificate confirms that the products meet the requirements of technical conditions WT/019/PIMOT/17 and authorizes us to use the registered safety mark B28. CARBONADO rims, in the course of laboratory tests, were subjected to load and impact tests, endurance strength to crushing and corrosion resistance was verified. The verification process also included the fixing elements from CARBONADO line: screws and caps. As a result, we can offer a complete set with tested properties.

TPMS Ready

CARBONADO rims are designed so as to ensure installation of practically every TPMS system based on pressure sensors from leading manufacturers. TPMS, i.e. system monitoring tire pressure, sends information about the pressure by radio from sensors placed inside the wheels to the on-board computer. As a result, the driver has control over tire pressure and may react to its drop in real-time. This is reflected in a direct manner in the safety of driving, slower wear of the tread and reduction of fuel combustion.